Cutting And Grinding Discs: Matching The Abrasive To The Job

Matching duty cycle to actual workload, rather than just chasing the highest amperage figure, is the difference between a machine that keeps up with the job and one that keeps tripping out halfway through it, and it's a question worth raising with a supplier before you buy, such as tecproducts.co.uk.

Abrasive discs look interchangeable on a shelf but perform very differently depending on what they're made from and what they're used on. Cutting discs are generally thin, designed to slice through material quickly with minimal heat build-up, while grinding discs are thicker and shaped to remove material from a surface or clean up a weld, rather than cut all the way through it.

A reliable, adequately sized compressed air supply is the part most first-time buyers underestimate. Undersized or contaminated air, whether from moisture, oil or an undersized compressor, is one of the most common causes of poor cut quality and shortened consumable life, so it's worth checking a machine's air requirements against what your compressor can actually deliver before you buy, not after.

Most domestic UK properties are supplied with single-phase power, typically 230V, which is more than adequate for light-duty inverter welders used for hobby work, repairs and general fabrication. Three-phase supply, commonly 400V to 415V across three live conductors, is standard in industrial premises and delivers power more efficiently to heavier equipment, which is why higher-output welders and plasma cutters, including some Fronius and ESAB machines, are often offered in a three-phase version.

Portability and power supply matter as much as the process itself. A stick welder will run from a generator or a domestic supply in places a gas bottle can't easily follow, while MIG and TIG set-ups need a gas cylinder and, for anything beyond light-gauge work, a heavier electrical supply. Workshop layout, the materials you weld most often, and how frequently the machine needs to travel are all worth weighing up before settling on one process.

Cutting capacity is usually described in terms of clean cut and maximum cut thickness, and the two are worth distinguishing. Clean cut is the thickness a machine handles with a good edge finish and reasonable speed, while maximum cut is the thickest material the machine will get through at all, usually slower and with a rougher edge. Buying with your typical material thickness in mind, rather than the thickest job you might occasionally face, generally gives a better day-to-day result.